{ "$schema": "/api/schemas/documents.schema.json", "apiVersion": "1.0.0", "generatedAt": "2026-06-17T23:49:39.838Z", "sourcePath": "src/main/data/docs", "docId": "10.5594-J16553", "document": { "abbrevTitle": "J SMPE", "abbrevTitle$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "abstract": "Although the carbon arc is usually considered as a continuous source of light, the experiments reported in this paper show that it may be used for the generation of light surges as well. If these surges are made to occur at a rate so fast that the arc stream does not have time to deionize between them, then the electrical circuit may be completely broken at the conclusion of each surge and closed again to initiate the next one. For longer periods between surges, a very low maintaining current is employed. The timing and duration of the light pulses are controlled by electronic switching of half-cycle current surges from an alternating-current supply. For a given size of carbon, much higher brilliancy and candle-power can be obtained in intermittent than in continuous operation; a brilliancy of 1600 candles per sq-mm is reported for a 7-mm carbon of the “Suprex” type. The efficiency of the intermittent carbon arc is limited by the thermal lag in the electrodes, in that they continue to radiate energy for a considerable period after the current is reduced to zero at the end of each surge.", "abstract$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "articleType": "research-article", "articleType$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "authors": [ "F. T. Bowditch", "R. B. Dull", "H. G. Macpherson" ], "authors$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "copyright": { "holder": "Society of Motion Picture and Television Engineers, Inc.", "holder$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "year": "1941", "year$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" } }, "copyright$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "docId": "10.5594-J16553", "docId$meta": { "confidence": "high", "note": "Derived from DOI 10.5594/J16553", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "docLabel": "Journal of the Society of Motion Picture Engineers ( Volume: 37, Issue: 7, July 1941)", "docLabel$meta": { "confidence": "medium", "note": "Composed from venue title, volume/issue and date", "source": "inferred", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "docTitle": "Characteristics of Intermittent Carbon ARCS", "docTitle$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "docType": "Journal Article", "docType$meta": { "confidence": "high", "note": "NLM
— SMPTE journal paper", "source": "inferred", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "doi": "10.5594/J16553", "doi$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "href": "https://doi.org/10.5594/J16553", "href$meta": { "confidence": "high", "note": "Constructed from DOI 10.5594/J16553", "source": "inferred", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "issn": { "print": "0097-5834", "print$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" } }, "issn$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "journalAcronym": "MIJR", "journalAcronym$meta": { "confidence": "high", "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/07302015 IBP DEPOSITS/Journal-256-Issues/smptej_37_7/MIJR15Vol37No7.xml)", "source": "parsed", "updated": "2026-06-17T00:17:09.425Z", "version": "smpte-journal-issue-xml@v1" }, "number": "7", "number$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "pages": "98–108", "pages$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "publicationDate": "1941-07-01", "publicationDate$meta": { "confidence": "high", "note": "Day absent in NLM source — padded to 01", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "publisher": "SMPTE", "publisher$meta": { "confidence": "high", "note": "Normalised to registry \"SMPTE\" convention from NLM publisher-name (The Society of Motion Picture and Television Engineers)", "source": "inferred", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "publisherLocation": { "city": "White Plains, NY", "city$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "country": "USA", "country$meta": { "confidence": "high", "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/07302015 IBP DEPOSITS/Journal-256-Issues/smptej_37_7/MIJR15Vol37No7.xml)", "source": "parsed", "updated": "2026-06-17T00:17:09.425Z", "version": "smpte-journal-issue-xml@v1" } }, "publisherLocation$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" }, "status": { "active": true, "active$meta": { "confidence": "medium", "note": "No explicit status in NLM source — journal papers default active", "source": "inferred", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" } }, "volume": "37", "volume$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J16553.xml)", "source": "parsed", "updated": "2026-05-22T21:44:19.125Z", "version": "smpte-journal-article-nlm@v1" } } }