{ "$schema": "/api/schemas/documents.schema.json", "apiVersion": "1.0.0", "generatedAt": "2026-06-17T23:49:39.838Z", "sourcePath": "src/main/data/docs", "docId": "10.5594-J14279", "document": { "abbrevTitle": "J SMPE", "abbrevTitle$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "abstract": "Non-uniformily of development is aggravated by short developing times and particularly at gammas far below gamma infinity. This non-uniformily can be partially overcome by agitation of the developer and a number of essentially different methods of developer agitation of interest, in motion picture work have been studied experimentally. The case of continuous agitation was studied by flowing the developer through a conduit in which the film was located. It was found that good uniformity is attainable not merely when turbulent flow is established but only when the intensity of turbulence is sufficiently great to reduce and make uniform the thickness of the quiescent liquid layer at the film surface. When agitation is of the intermittent type such as supplied by some of the present-day submerged jet systems or the cascade method, increased agitation is attainable usually by increased frequency of jet application rather than by greater liquid flow. Little improvement can be obtained by moderate increases in the film running speed or the rate of general circulation of developer in most of the present-day machine tanks. The agitation intensity could be increased much beyond the levels of present-day practice but, except for a slight reduction in fog in certain cases, the effect of increased agitation on quality would not be significant. Methods of agitation are discussed in relation to the problems of application to machine design.", "abstract$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "articleType": "research-article", "articleType$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "authors": [ "C. E. Ives", "E. W. Jensen" ], "authors$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "copyright": { "holder": "Society of Motion Picture and Television Engineers, Inc.", "holder$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "year": "1943", "year$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" } }, "copyright$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "docId": "10.5594-J14279", "docId$meta": { "confidence": "high", "note": "Derived from DOI 10.5594/J14279", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "docLabel": "Journal of the Society of Motion Picture Engineers ( Volume: 40, Issue: 2, February 1943)", "docLabel$meta": { "confidence": "medium", "note": "Composed from venue title, volume/issue and date", "source": "inferred", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "docTitle": "The Effect of Developer Agitation on Density Uniformity and Rate of Development", "docTitle$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "docType": "Journal Article", "docType$meta": { "confidence": "high", "note": "NLM
— SMPTE journal paper", "source": "inferred", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "doi": "10.5594/J14279", "doi$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "href": "https://doi.org/10.5594/J14279", "href$meta": { "confidence": "high", "note": "Constructed from DOI 10.5594/J14279", "source": "inferred", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "issn": { "print": "0097-5834", "print$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" } }, "issn$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "journalAcronym": "MIJR", "journalAcronym$meta": { "confidence": "high", "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/08202015 BACKFILE JOURNAL FRESH/smptej_40_2/MIJR15Vol40No2.xml)", "source": "parsed", "updated": "2026-06-16T18:14:32.753Z", "version": "smpte-journal-issue-xml@v1" }, "number": "2", "number$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "pages": "107–136", "pages$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "publicationDate": "1943-02-01", "publicationDate$meta": { "confidence": "high", "note": "Day absent in NLM source — padded to 01", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "publisher": "SMPTE", "publisher$meta": { "confidence": "high", "note": "Normalised to registry \"SMPTE\" convention from NLM publisher-name (The Society of Motion Picture and Television Engineers)", "source": "inferred", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "publisherLocation": { "city": "White Plains, NY", "city$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "country": "USA", "country$meta": { "confidence": "high", "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/08202015 BACKFILE JOURNAL FRESH/smptej_40_2/MIJR15Vol40No2.xml)", "source": "parsed", "updated": "2026-06-16T18:14:32.753Z", "version": "smpte-journal-issue-xml@v1" } }, "publisherLocation$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" }, "status": { "active": true, "active$meta": { "confidence": "medium", "note": "No explicit status in NLM source — journal papers default active", "source": "inferred", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" } }, "volume": "40", "volume$meta": { "confidence": "high", "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J14279.xml)", "source": "parsed", "updated": "2026-05-22T20:40:11.684Z", "version": "smpte-journal-article-nlm@v1" } } }