{
  "$schema": "/api/schemas/documents.schema.json",
  "apiVersion": "1.0.0",
  "generatedAt": "2026-06-17T23:49:39.838Z",
  "sourcePath": "src/main/data/docs",
  "docId": "10.5594-J07481",
  "document": {
    "abbrevTitle": "J SMPE",
    "abbrevTitle$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "abstract": "It is well known that the properties of developers change during use as a result of depletion of the developing agents and accumulation of reaction products. This change is greatest for low-energy developers such as those of the borax type, and results in (1) a reduced development rate, and (2) a lowering of effective emulsion speed. These two effects may be offset to some extent by increasing the development time and by adding booster solutions to revive the developer. Another method of securing a more uniform degree of development throughout the life of a developer consists in using two developer baths in succession. Three types of two-bath developers have been investigated, as follows: (1) bath A contained all the developing agents plus sodium sulfite; bath B, all the alkali plus the balance of the sulfite. (2) Both baths contained developing agents. (3) Both baths were of identical composition, the first bath being replaced by the second as it became exhausted. The results of the investigation showed that Type I is the most satisfactory developer combination and with this method it is possible to obtain an almost constant gamma with only a slight loss of emulsion speed over a fairly wide range of time of development. A formula is also suggested for the development of variable density sound negatives. The application of two-bath developers to machine, and rack and tank systems is described.",
    "abstract$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "articleType": "research-article",
    "articleType$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "authors": [
      "J. I. Crabtree",
      "H. Parker",
      "H. D. Russell"
    ],
    "authors$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "copyright": {
      "holder": "Society of Motion Picture and Television Engineers, Inc.",
      "holder$meta": {
        "confidence": "high",
        "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
        "source": "parsed",
        "updated": "2026-05-22T19:19:44.900Z",
        "version": "smpte-journal-article-nlm@v1"
      },
      "year": "1933",
      "year$meta": {
        "confidence": "high",
        "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
        "source": "parsed",
        "updated": "2026-05-22T19:19:44.900Z",
        "version": "smpte-journal-article-nlm@v1"
      }
    },
    "copyright$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "docId": "10.5594-J07481",
    "docId$meta": {
      "confidence": "high",
      "note": "Derived from DOI 10.5594/J07481",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "docLabel": "Journal of the Society of Motion Picture Engineers ( Volume: 21, Issue: 1, July 1933)",
    "docLabel$meta": {
      "confidence": "medium",
      "note": "Composed from journal title, volume, issue and date",
      "source": "inferred",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "docTitle": "Some Properties of Two-Bath Developers for Motion Picture Film",
    "docTitle$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "docType": "Journal Article",
    "docType$meta": {
      "confidence": "high",
      "note": "NLM <article> — SMPTE journal paper",
      "source": "inferred",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "doi": "10.5594/J07481",
    "doi$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "href": "https://doi.org/10.5594/J07481",
    "href$meta": {
      "confidence": "high",
      "note": "Constructed from DOI 10.5594/J07481",
      "source": "inferred",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "issn": {
      "print": "0097-5834",
      "print$meta": {
        "confidence": "high",
        "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
        "source": "parsed",
        "updated": "2026-05-22T19:19:44.900Z",
        "version": "smpte-journal-article-nlm@v1"
      }
    },
    "issn$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "journalAcronym": "MIJR",
    "journalAcronym$meta": {
      "confidence": "high",
      "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/07082015 BACKFILE FOR JOURNAL AND CONFERENCES/smptej_21_1/MIJR15Vol21No1.xml)",
      "source": "parsed",
      "updated": "2026-06-16T16:11:59.617Z",
      "version": "smpte-journal-issue-xml@v1"
    },
    "number": "1",
    "number$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "pages": "21–53",
    "pages$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "publicationDate": "1933-07-01",
    "publicationDate$meta": {
      "confidence": "high",
      "note": "Day absent in NLM source — padded to 01",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "publisher": "SMPTE",
    "publisher$meta": {
      "confidence": "high",
      "note": "Normalised to registry \"SMPTE\" convention from NLM publisher-name (The Society of Motion Picture and Television Engineers)",
      "source": "inferred",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "publisherLocation": {
      "city": "White Plains, NY",
      "city$meta": {
        "confidence": "high",
        "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
        "source": "parsed",
        "updated": "2026-05-22T19:19:44.900Z",
        "version": "smpte-journal-article-nlm@v1"
      },
      "country": "USA",
      "country$meta": {
        "confidence": "high",
        "note": "Parsed from journal_metadata XML (_source/SMPTE/APTARA/DL Project Files/07082015 BACKFILE FOR JOURNAL AND CONFERENCES/smptej_21_1/MIJR15Vol21No1.xml)",
        "source": "parsed",
        "updated": "2026-06-16T16:11:59.617Z",
        "version": "smpte-journal-issue-xml@v1"
      }
    },
    "publisherLocation$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    },
    "status": {
      "active": true,
      "active$meta": {
        "confidence": "medium",
        "note": "No explicit status in NLM source — journal articles default active",
        "source": "inferred",
        "updated": "2026-05-22T19:19:44.900Z",
        "version": "smpte-journal-article-nlm@v1"
      }
    },
    "volume": "21",
    "volume$meta": {
      "confidence": "high",
      "note": "Parsed from NLM article XML (_source/SMPTE/HIGHWIRE/Source Bak/smptej/10.5594_J07481.xml)",
      "source": "parsed",
      "updated": "2026-05-22T19:19:44.900Z",
      "version": "smpte-journal-article-nlm@v1"
    }
  }
}